
Enable and Event Registers
The conditional Registers are continuously monitored. When a change is detected in a register bit
which is enabled, the power supply will generate an SRQ message.
The SRQ message is: “Inn” terminated by CR, where the nn is the p
ower supply address. The SRQ
will be generated either in Local or Remote mode.
14 for details of the Enable and Event registers.
The Fault Enable Register is set to the enable faults SRQs.
where nn is hexadecimal (if
nn=”00”, no fault SRQs will
The Fault Event will set a bit if a condition occurs and it is Enabled. The register is
FEVE?, CLS or RST commands are received.
clear the Fault Event Regi
ter. (The Fault Event Regi
ter is not cleared by RST)
Comments to this Manuals